Homenlifestylehome

You might need to call one of our top plumbers Sydney if you have a blocked pipe, a dripping faucet, or high water pressure. That’s a reason to contact your plumber.

Many homeowners lack basic plumbing skills. Many homeowners end up worsening their plumbing problems by trying to fix them themselves.

You’ll be responsible for costly repairs to your property if you make a problem worse. There are still things you can do to avoid calling your plumbing professional every time a problem arises.

These are 10 tips and tricks that you need to know about plumbing. These tips could save you money on plumbing services.

Find out where the main valves are located

Know where the main valves are before you move into a new home. This will allow you to shut off the water in an emergency, such as a burst pipe.

Know where the main drain line is. In case you need to clean out the sewer line regularly, it is important to know the details of the access points. Some apartments and condos might not have separate valves.

Learn what flushable is and what isn’t

Toilet clogs can be caused by flushing anything but toilet paper and waste. Toilet clogs can be caused by even flushable wipes.

Do not dump garbage down the drain

You should not dump any grease, coffee grounds, or vegetable peelings down the drain.

They will most likely clog your drain. It is also a good idea to read the manual for your kitchen garbage disposal. This will help you to understand what your garbage disposal can handle.

Avoid puncturing your pipes

Before you start drilling holes in the ceiling, floor, or wall with nails, make sure to check if there is a supply or drainage line behind it.

You don’t want to accidentally puncture the pipes. To locate pipes hidden behind walls, you can use a Stud Finder.

The cost of a stud finder is very affordable. You can also use an endoscopic camera to inspect pipes, by running them through a wall.

Vacuuming is your friend

To remove clogs from small and hard objects like toothbrushes, combs, and toys for children, use a dry and wet vacuum.

Vacuuming is more effective at removing small objects than a plunger, which pushes them further down the drainage. It will be harder to remove an object if it is pushed farther down the drainage.

Plunging

Plunging can be used to clear minor clogs from sinks and drains. If you need to clean the sink traps, use a sink plunger to push water through them. Then, remove the sink trap. This will make cleaning up much easier and less messy.

Plumber’s tape is a great tool!

To prevent water from leaking around joints and fittings, it is important to seal pipe threads. High-quality plumber tape can seal pipe threads. Teflon tape is also known to be plumber’s tape.

Before connecting plumbing joints and fittings, wrap the threads three times with the tape. Yellow tape is specifically designed to be used in gas lines, while white plumber tape works well for household plumbing.

Check your plumbing system regularly for any leaks

It’s important to inspect any leaks during a plumbing project. Let the water flow through the pipes to do this. You can open and close the valves. Small leaks are easy to spot. Any leaking connections should be repaired.

Plumbing leaks should not be ignored

Increased water bills can be caused by constant drips from pipes and faucets. Leaking faucets can waste thousands of gallons worth of precious water each day.

Toilets can waste over 100 gallons per day. Water leaks should be fixed as soon as possible. It is important to fix any leak immediately, even the smallest.

Do not tighten your plumbing fittings too much

When doing DIY plumbing projects, homeowners tend to over-tighten the plumbing connections and fittings. This can cause stripped screws and broken bolts. Hand-tightening is the best type of connection.